Shading
VBR FRONT-MOUNTED SYSTEMS
Whether for the shading of a new building or as part of a renovation - the use or better attachment of a front element is almost always possible. The systems from Beck+Heun can be used flexibly - regardless of window systems and sizes. The installation in front of the window does not create any thermal bridges. In addition, this can also be done at a later date. Thanks to their discreet design and the use of different roller shutter panels, the VBR FRONT-MOUNTED SYSTEMS are timeless and offer a wide range of possibilities.
All variants at a glance
The roller shutter solutions in front of the window
VBR Standard
- Bottom part 20° bevelled
- Roll-formed or extruded aluminium
VBR Quarter Round
- Quarter round aperture
- Roll formed aluminium
VBR ROUND
- Round bezel
- Roll-formed or extruded aluminium
VBR PLASTER
- Bottom part 20° bevelled,
1.5 mm extruded - For on-site plaster base
- Roll formed aluminium
VBR FRONT-MOUNTED SYSTEMS - Design variants
Extruded box | Roll formed box | Revision outside | Can be plastered over | Optionally with INSECT SCREENS | |
VBR Standard | √ | √ | √ | √ | |
VBR Quarter Round | √ | √ | √ | ||
VBR ROUND | √ | √ | √ | √ | |
VBR PLASTER | √ | √ | √ 1) | √ |
1) For on-site plaster base
VBR FRONT-MOUNTED SYSTEMS
A wealth of variation in view - Technical, practical, good
Box body
Depending on the requirements and building situation, different box shapes are available. Each of them has an inspection panel on the outside and therefore offers reduced heat loss. In addition, the systems can be easily retrofitted.
Mechanically operable display system
The opening system makes it possible to supply the room with fresh air even when the roller shutter is down.
Hinge connection
AllFRONT-MOUNTED BOXES are equipped with a hinge connection. The external inspection panel guarantees that service and repair work can be carried out quickly and cleanly.
VBR FRONT-MOUNTED SYSTEMS
The system components at a glance
GUIDE RAILS
Sturdy, extruded aluminium profile in thick lacquer-coated box colour. Integrated rubber piping and brush seals ensure quiet armour running.
Extruded aluminium
Dimensionally stable, high-quality roller shutter boxes made of extruded aluminium are robust, resilient, durable and low-maintenance.
Roll formed aluminium
Roller shutter boxes made of roll-formed aluminium trims not only look very good, but also impress with a wide variety of shapes, are weather-resistant and offer a long service life.
VBR FRONT-MOUNTED SYSTEMS
Special equipment and accessories
Roller shutter profile
The PVC and aluminium roller shutter profiles are enormously stable and protect against noise, heat loss and burglars.
INSECT SCREENS
An integrated insect protection roller blind can keep out pests. When it is not needed, it disappears invisibly and protected in the roller shutter box.
Drive via belt
The armour is easily rolled up and down by a 12 mm wide belt that sits on a steel guide roller with needle bearings.
Drive via motor
On request, the VBR FRONT-MOUNTED SYSTEMS can be equipped with a motor. You have the choice between
control by permanently installed switch or by radio remote control.