Accessories
ACCESSORIES STANDARD EQUIPMENT
Belt guides, bearings & Co.
Belt guides G+T with guide roller, long or short
- Form-fit insert with assembly foam
- With guide roller and double brush seal
Extension adapter
- Length: 20 mm
- For extending the G+T belt guide in the case of thicker leg thicknesses in the roller shutter box
Electrical junction box
- For preparing a power connection in the roller shutter box, for example for later motorisation.
- Airtight for foaming
- Installation depth: 62 mm
- D = ~50 mm
- Incl. red (bottom) plaster cover
Inlet belt winder large/small
Small:
- For 5 m long webbing in 22 mm width
- Hole spacing: 165 mm
- With cover plate made of plastic in white
Large:
- For 10 m long gear belt in 22 mm width
- Hole spacing: 165 mm
- With cover plate made of plastic in white
Extension cap
- For G+T belt guide
- Increases the distance of the belt from the wall by 10 mm (e.g. in the bathroom in the case of a wall construction with tiles).
Cover frame
- For covering the G+T belt guide
Inspection cover
- Surface-mounted cover for revision of the electrical junction box
- White plastic
- Wallpaperable
Belt box
- Belt box small for insertion into the masonry
- Hole spacing: 165 mm
- Size: 190 x 50 x 190 mm
Webbing
- Width: 22 mm
- Colour: grey/grey
- On roll optionally 5, 9 or 50 m long
Belt tension gear
- Reduction gear 2:1 for 22 mm webbing including gear bearing
- D = 180 mm
Telescopic shaft
Set consisting of:
- 60 mm octagonal shaft with wall thickness 0.6 mm or reinforced 1 mm
- Telescopic piece
- Roller cap with eight-pin
- Sliding belt pulley
Clip spring standard
- For suspending the roller shutter from the steel shaft by means of spring steel (L 200 mm) and plastic holder (L 250 mm).
- Optionally for mini and maxi roller shutters
Belt box B+H Neopor®
- Material: Neopor®
- Variable 45 mm lateral adjustment range and plaster thickness adjustment
- Condensation protection guarantee
- Lambda = 0.075 W/(mK) (under standard conditions)
- Alignment to the belt outlet on site
- Available in the following sizes (WxHXT):
119 x 247 x 237 mm
119 x 494 x 237 mm
Bearing holder flat
- Bearing holder for BUILT-IN BOXES with ball bearing and plastic inner ring
Bearing holder saw tooth
- Bearing holder flat with ball bearing and plastic inner ring as well as saw tooth tab for easy height adjustment
Fixed shaft connectors
- Mandatory for tank mounting on electronic motors with self-learning or plug & play function